February 2013
4-281
ColorQube® 9303 Family
REP 75.9
Repairs/Adjustments
3. Turn tray 5 onto its end to access the fixing screws on the docking latch main bracket. If
tray 5 has a 11x17 / A3 or 8.5 x 11 / 14 kit then turn the tray 5 on it’s side. Figure 2.
Figure 2 Remove the latch assembly
4. Note the orientation of the latches and then remove the docking latches, Figure 3.
Figure 3 Remove docking latch
Replacement
1. The replacement is the reverse of the removal procedure.
2. Check that the tabs are located correctly on the base plate when refitting the latch assem-
bly, Figure 4.
Figure 4 Location of the tabs
3. Check that the docking latch spring is located correctly.
Remove 2 screws
Remove the fixing screw and
remove the docking latch
Check that the tabs are located correctly in the base
To Next Page
Loading...
Need help?
General
