February 2013
6-55
ColorQube® 9303 Family
GP 18, GP 19
General Procedures/Information
GP 18 Machine Lubrication
Purpose
To give information on the use of lubricants.
Procedure
CAUTION
Only use lubricants as directed. Incorrect use of lubricants could seriously affect the perfor-
mance of the machine.
Take the following precautions when performing machine lubrication:
• Wear disposable gloves, PL 26.10 Item 5.
• Only use lubricants that are specified in the Parts List.
• Only lubricate parts of the machine as directed in the relevant RAPs, Repairs and Adjust-
ments etc.
• Apply only the smallest amount of lubricant, sufficient to lubricate the parts. To prevent
contamination, remove any surplus lubricant before the machine is run.
• Take great care not to contaminate other parts of the machine with the lubricant.
GP 19 Machine SIM Card Matrix
Purpose
To identify the correct SIM card with the correct machine configuration, Figure 1.
Procedure
Install the SIM card that is compatible with the machine:
• 9301 machine indicated by the letter A or no coloured strip.
• 9302 machine indicated by the letter B or a green strip.
• 9303 machine indicated by the letter C or a yellow strip.
NOTE: When the machine is installed, the machine will only recognize a SIM with the
machines serial number written to it. If your customer has lost the SIM or the SIM has been
damaged, a pre-programmed SIM must be ordered. This can be obtained by escalating the
problem through normal channels, and a pre-programmed SIM with the customer’s serial num
-
ber will be sent.
NOTE: The SIM card is also referred to as the product enablement key.
The following information is required when ordering a pre-programmed SIM:
• Machine serial number.
• Machine speed, 9301, 9302 or 9303.
• Billing plan, 2 tier or 3 tier.
• Service plan, WW metered, XC / XE sold or DMO sold.