February 2013
6-124
ColorQube® 9303 Family
GP 48, GP 49
General Procedures/Information
GP 48 How to Re-Enter Optional Feature Installation Keys
Purpose
To explain how to re-enter optional feature installation keys if they fail to reload after an Altboot
or after a hard disk replacement.
NOTE: McAfee Integrity Control is an optional features available on the ColorQube 9303F with
software version 071.XXX.XXX.XXX.
Procedure
Perform the following:
1. Obtain the valid Feature Installation key(s) by either:
a. Asking the customer.
b. Logging onto the SWAP portal, www.xeroxlicensing.xerox.com/fik. From the Wel-
come screen, select Find an existing key. Enter the machine serial number in the
window, then select Next.
c. Contacting the Licensing Admin Centre (USSG/XCL) or the Xerox sales representa-
tive (XE/DMO).
2. Enter the Feature Installation key(s). Perform the following:
a. Press the Machine Status key.
b. Select the Tools tab.
c. Select Device Settings, then General.
d. Select Feature Installation. Enter the Feature Installation key, then select OK. If nec-
essary, enter the second Feature Installation key.
GP 49 USB Connection Mode
Purpose
To set the USB connection mode.
Procedure
Perform the following:
1. Enter Customer Administration Tools, GP 5.
2. Press the Machine Status button.
3. Select Tools.
4. Select Network Settings.
5. Select USB Settings.
6. Select Software Tools.
7. Select Save.
8. Exit Customer Administration Tools, GP 5.