February 2013
4-16
ColorQube® 9303 Family
REP 1.8, REP 1.9
Repairs/Adjustments
REP 1.8 Front Door Interlock Switch
Parts List on PL 1.15
Removal
WARNING
Switch off the electricity to the machine. Refer to GP 14. Disconnect the power cord
from the customer supply while performing tasks that do not need electricity. Electricity
can cause death or injury. Moving parts can cause injury.
WARNING
Take care during this procedure. Sharp edges may be present that can cause injury.
1. Open the front door.
2. Remove the front door interlock switch, Figure 1.
Figure 1 Front door interlock removal
Replacement
1. Replacement is the reverse of the removal process.
REP 1.9 Power Supply Unit
Parts List on PL 1.15
Removal
WARNING
Switch off the electricity to the machine. Refer to GP 14. Disconnect the power cord
from the customer supply while performing tasks that do not need electricity. Electricity
can cause death or injury. Moving parts can cause injury.
WARNING
Take care during this procedure. Sharp edges may be present that can cause injury.
NOTE: Some machines may be fitted with a W/TAG 001 power supply unit that has a blanking
cover instead of the sliding cover at the main power cord socket.
1. Remove the rear cover, PL 81.10 Item 1.
2. Remove the main power cord, PL 1.15 Item 1.
3. Disconnect the LCSS power cord, PL 12.75 Item 8, if installed, or the HVF power cord. PL
12.140 Item 4 if installed.
4. Remove the rear cover, PL 70.25 Item 8
5. Disconnect the harnesses, Figure 1.
1
Lever out the switch body using a flat
blade screwdriver
2
Disconnect the wires and
remove the switch
To Next Page
Loading...
Need help?
General
