February 2013
4-403
ColorQube® 9303 Family
ADJ 12.3-171
Repairs/Adjustments
Figure 3 Closing the stapler
6. Open the stapler fully by use of the stapler gear, Figure 3, then remove the alignment tool.
7. Perform the adjustment on the other stapler anvil if necessary.
8. Check the operation of the stapler by making a few stapled sets using 2 sheets of 80gsm
(20 pound) paper. check the quality of the staple clinch.
1
Rotate the stapler gear counterclockwise
to begin closing the stapler.
2
Continue to rotate the
stapler gear so that the
two protrusions on the
tool engage with the
depressions in the
anvil. Move the anvil if
necessary using the
two clamp screws.
3
Continue to rotate the stapler gear
until the anvil is tightly clamped by
the alignment tool and the stapler
will close no further.
4
Tighten the two screws alternately a little at a time, while
holding the free screw with a finger. Ensure that the anvil
does not move as the screws are tightened.
Anvil
Spacer
Clamp plate
To Next Page
Loading...
Need help?
General
