February 2013
6-94
ColorQube® 9303 Family
GP 32
General Procedures/Information
Figure 7 Vertical displays
LED Test
This test verifies that all LED’s are functioning properly. On pressing the associated hard key
the LED will be switched on. Each LED can be instructed to turn on, off or blink.
1. Select the test.
2. Select the function on the UI screen and observe that the LED is lit, Figure 8.
3. Select Back to return to the main menu.
Figure 8 LED test display
Audio Tone Test
This test is used to verifying that the audio tone on the UI is working correctly. Upon activation
of the test, the UI will emit a selection of sound tones and sound level tests.
1. Press hard key 1 to select Sound Test.
The audio duration ranges from 2 seconds for sound 1 to 4 tests, 5 seconds for the basic
sound and approximately 10 seconds for the All tones tests. Audio levels can be verified
by setting them low, medium or high.
2. Press the hard key 0 to return to the main menu.
Table 4 Audio tone test
Key Test Description
1 Sound Test Nominal (high)
2 Sound 1 Test 500Hz (high)
3 Sound 2 Test 1000Hz (medium)
4 Sound 3 Test 2500Hz (medium)
5 Sound 4 Test 4000Hz (high)
6 Set Level Low Modifies the volume used in the Test 1 to 5
7 Set Level Medium Modifies the volume used in the Test 1 to 5
8 Set Level High Modifies the volume used in the Test 1 to 5
9 All Tones Test Perform each of the following tests sequentially: sound
test, sound 1, sound test 3 sound test 4
0 Back