Xerox ColorQube 9303 Series - Page 77

February 2013
2-53
ColorQube® 9303 Family
05-256-00, 05-257-00
Status Indicator RAPs
05-256-00 Eject Count Error RAP
05-256-00 The number of ejections from the DADH did not match the number of feeds.
Procedure
WARNING
Ensure that the electricity to the machine is switched off while performing tasks that do
not need electricity. Refer to GP 14. Disconnect the power cord. Electricity can cause
death or injury. Moving parts can cause injury.
1. Switch off, then switch on the machine, GP 14.
05-257-00 Unknown Document Size RAP
05-257-00 The DADH has failed to detect the document size during pre-feed.
Initial Actions
WARNING
Ensure that the electricity to the machine is switched off while performing tasks that do
not need electricity. Refer to GP 14. Disconnect the power cord. Electricity can cause
death or injury. Moving parts can cause injury.
• Make sure that a bright light is not above the DADH input tray. Refer to TAG D-007 and
check size sensor 1 and size sensor 2. If necessary, adjust the position of the machine.
• Remove all documents from the DADH and input tray.
• Make sure that the sensors and the area around the sensors are clean.
Procedure
NOTE: The DADH width sensor is a potentiometer. The arm on the potentiometer is attached
to the width guides. This gives a variable voltage to indicate the paper width setting.
Enter dC330 code 05-221 to check the DADH tray size sensor 1 Q05-221, PL 5.35 Item 8.
Actuate Q05-221.
The display changes.
YN
Refer to WD 5.2. Check Q05-221.
References:
• GP 11 How to Check a Sensor.
• P/J190, DADH PWB.
• 01D +5V Distribution RAP.
• 01L 0V Distribution RAP.
Install new components as necessary:
• DADH tray size sensor 1, PL 5.35 Item 8.
• DADH PWB, PL 5.10 Item 5.
Enter dC330 code 05-222 to check the DADH tray size sensor 2 Q05-222, PL 5.35 Item 8.
Actuate Q05-222.
The display changes.
YN
Refer to WD 5.2. Check Q05-222.
References:
• GP 11 How to Check a Sensor.
• P/J190, DADH PWB.
• 01D +5V Distribution RAP.
• 01L 0V Distribution RAP.
Install new components as necessary:
• DADH tray size sensor 2, PL 5.35 Item 8.
• DADH PWB, PL 5.10 Item 5.
Open the DADH top cover. Enter dC330 code 05-204 to check the DADH feed sensor, Q05-
204, PL 5.15 Item 2. Actuate Q05-204.
The display changes.