February 2013
4-18
ColorQube® 9303 Family
REP 1.9
Repairs/Adjustments
Replacement
1. Replacement is the reverse of the removal process.
2. If a W/TAG 001 power supply unit is being installed, the blanking cover, PL 70.25 Item 14
(supplied with the new power supply unit) must be installed into the lower rear cover, Fig
-
ure 4.
Figure 4 Blanking cover location
3. Install the ribbon cable JDC2 and note the location of the support lugs on the rear of the
power supply unit, Figure 5.
Figure 5 Install the ribbon cable
CAUTION
Ensure that wires are not pinched between the frame and the back of the power supply during
installation
Blanking cover
Blanking cover not installed
Blanking cover installed
1
Connect the ribbon
cable to JDC2
Support lugs on the back of the power supply
unit to be located on the frame brackets
To Next Page
Loading...
Need help?
General
