Xerox ColorQube 9303 Series - Page 82

February 2013
2-58
ColorQube® 9303 Family
05-330-00, 05-331-00
Status Indicator RAPs
YN
Go to the 05C DADH Motor Failure RAP.
While MOT 05-074 runs, stack the code 05-062 to energize the DADH feed clutch, CL05-062.
NOTE: The feed clutch disengages after 30 seconds. The feed motor stops after 3 minutes.
CL05-062 energizes, the nudger rolls and the feed rolls rotate.
YN
Perform the steps that follow:
• Go to the 05D DADH Feed Clutch Failure RAP and check CL05-062.
• ADJ 5.1 DADH Drive Belt Adjustment.
Enter dC330 code 05-098, to run the DADH nudger motor. The feed roll assembly lowers,
then raises after 10 seconds.
YN
Refer to WD 5.1. Check the nudger motor.
References:
• GP 10 How to Check a motor.
• P/J183, DADH PWB and P/J201.
• 01H +24V Distribution RAP.
• 01L 0V Distribution RAP.
Install new components as necessary:
• DADH nudger motor, PL 5.15 Item 5.
• DADH feed assembly, PL 5.15 Item 18.
• DADH PWB, PL 5.10 Item 5.
Perform the steps that follow:
• Check that the DADH feed sensor, Q05-204 is installed correctly, Figure 2. If necessary,
install a new feed roll assembly, PL 5.15 Item 1.
• Ensure the feed motor drive belt and DADH CVT motor belt are tensioned correctly, ADJ
5.1.
• When large documents are fed (A3 or 11x17 inch), check the items that follow:
– Check that the DADH CVT motor rotates freely, refer to the 05C DADH Motor Failure
RAP.
– Check the CVT motor drive belt, refer to ADJ 5.1 DADH Drive Belt Adjustment.
– Check that the CVT roll is clean and rotates freely, refer to ADJ 5.4.
– If necessary install a new DADH feed motor, PL 5.25 Item 9.
• Go to the 05D DADH Feed Clutch Failure RAP and check CL05-062.
• Make sure that the size of the documents are sensed correctly. Refer to the 05-257-00
Document Size Sensor Failure RAP.
Figure 1 Component location
Clip
Feed yoke shaft
Front and rear feed
gates
Feed yoke and
spring
Front and rear
feed gates