February 2013
4-196
ColorQube® 9303 Family
REP 12.58-171, REP 12.59-171
Repairs/Adjustments
REP 12.58-171 Not Used
REP 12.59-171 Crease Roll Gate Assembly
Parts List on PL 12.180.
Purpose
This procedure is used to repair the following components:
• Crease roll gate rack gear, PL 12.180 Item 8.
• Crease roll gate rack drive gear, PL 12.180 Item 13.
• Crease roll gate rack, PL 12.180 Item 14.
• Crease roll gate front guide, PL 12.180 Item 15.
• Crease roll gate rear guide, PL 12.180 Item 16.
• Crease roll gate, PL 12.180 Item 19.
Removal
WARNING
Take care during this procedure. Sharp edges may be present that can cause injury.
WARNING
Switch off the electricity to the machine GP 14. Disconnect the power cord from the cus-
tomer supply while performing tasks that do not need electricity. Electricity can cause
death or injury. Moving parts can cause injury.
1. Open the HVF BM front door and fully pull out the BM.
2. Remove the crease blade knob (6d), PL 12.150 Item 4.
3. Remove the crease roll handle (6c), PL 12.150 Item 5.
4. Remove the BM front cover, PL 12.150 Item 3.
5. Remove the BM right hand cover, REP 12.56-171.
6. Remove the crease roll assembly, REP 12.52-171.
7. Remove the crease roll gate motor, REP 12.24-171.
To Next Page
Loading...
Need help?
General
