General Procedures and Information
Phaser 3200MFP / Workcentre PE220 04/07 6-13
Safety Features
Overheating prevention measures
- 1st protection device: Machine stops when overheated
- 2nd protection device: Software shuts down when overheated
- 3rd protection device: Thermostat cuts of power to the lamp.
Safety devices
- Fuser power is cut off when the front cover is opened
- LSU power is cut off when the front cover is opened
- The temperature of the fuser cover's surface is maintained at less than 80°C to protect the
user. A caution label is easily seen when the rear cover is opened.
To Next Page
Loading...
