General Procedures and Information
Phaser 3200MFP / Workcentre PE220 04/07 6-19
2. ON HOOK state Characteristic
DC Resistance
- DP Dial Mode (Direct Current 30mA) : 50 ~ 300ohm
- DTMF Dial Mode (Direct Current 20mA) : 50 ~ 540ohm
3. Ring Sensitivity
Ring detection Voltage : 40Vrms 150Vrms (condition :Current=25mA,Frequency=15Hz)
product Margin : 30Vrms 150Vrms
Ring detection Frequency : 15.3Hz 68Hz (condition : Voltage=45Vrms,Current=25mA )
product Margin : 15Hz 70Hz
Ring detection Current : 20mA 100mA (condition : Voltage=40Vrms,Frequency=20Hz)
product Margin : over 15mA
4. False Ring Sound
Ring Frequency : 750 Hz + 1020 Hz
Ring interrupt Cycle : On/Off depending on input Ring Signal Cycle.
Engine Paper Feeding
1. Feeding Type: MP Cassette Type
2. Feeding Standard: Centre Loading
3. Feeding Qty:
PE220 - Cassette 150 sheets (75g/, 20lb paper standard)
Phaser 3200 - Cassette 250 sheets (75g/, 20lb paper standard)
1 sheet (Paper, OHP, Envelope etc.)
4. Separating Type: Cassette - Friction Pad Type
5. Manual Tray: 1 sheet
6. Drive Type: Driving by Gearing from Main Motor
7. Pick_up Roller Driver: Solenoid
8. Pick up Roller Rubber Material: EPDM+IR =1.3 or more LD (Laser Diode)
9. Pick up Velocity: 94.8731mm/Sec (Process: 93.0667mm/sec)
10.Paper detecting Sensor: Photo Sensor
11.Paper Size Sensor: None
12.Paper Separating Pad Material: NBB 52 °, =0.8~1.2
13. Pick_up Roller RPM: 47.683 RPM
14.Feeding Pressure (Same as Transfer Roller)
15. Paper Exit Type: Face Down
16.Exit Sensor: Photo Sensor
To Next Page
Loading...
Need help?
General
