133
Customize Menu Settings for Individual Use (Set Mode)
Set Mode: TX/RX Menu Operations
Switching the Receive Mode
Manually switch to a suitable mode (radio wave type) according to the frequency band by
selecting [1 MODE] → [3 RX MODE].
For details, see “Changing the Mode” on page 48.
Setting the Squelch Type for the Digital Mode
Set the squelch type for the digital mode.
1 Touch [2 DIGITAL].
2 Touch [1 SQL TYPE].
3 Rotate the DIAL to select [SQL TYPE], then press the key.
4 Rotate the DIAL to select the desired squelch type.
OFF Audio is always output upon receiving a digital signal from a Yaesu
transceiver.
CODE Audio is output only when receiving a signal with a corresponding
SQL CODE.
BREAK Audio is output regardless of any squelch code when the remote
station transmits with BREAK set.
Remark The default setting: OFF
5 Press the key.
6 Rotate the DIAL to select [SQL CODE], then press the key.
7 Rotate the DIAL to select the desired code.
Set SQL CODE any one of 126 types (001 to 126).
Setting the Pop-up Time of the Remote Station Information
Set the time duration to display the remote station information such as the call sign, on
the LCD.
1 Touch [2 DIGITAL].
2 Touch [2 DIGI POPUP].
3 Rotate the DIAL to select the desired setting.
OFF The remote station information is not displayed.
BND2s to
60s
Set the time duration to display the remote station information (2 to
60 seconds).
BND2s / BND4s / BND6s / BND8s / BND10s / BND20s / BND30s /
BND60s
BNDCNT The remote station information is continuously displayed.
Remark The default setting: BAND 10 seconds
To Next Page
Loading...
