152
Customize Menu Settings for Individual Use (Set Mode)
Set Mode: CONFIG Menu Operations
Limit the time of a continuous transmission (TOT Function)
Set the transceiver to automatically return to receive mode after transmitting continuously
for a certain period of time. The TOT function limits inadvertent transmission of
unnecessary signals, and unwanted battery power consumption (time-out timer function).
1 Rotate the DIAL, then touch [20 TOT].
2 Rotate the DIAL to set the time for the transceiver to automatically return to receive
mode state in steps of 30 seconds.
OFF/30 SEC to 10 MIN
Selecting OFF disables the TOT function.
Remark The default setting: OFF (European version: 3 MIN)
Tips
• When the time-out timer function is active, a beep is emitted when a continuous transmission nears
the set time. About 10 seconds later, the transceiver returns to the receive mode.
• The TOT setting is retained until “OFF” is selected in step 2 above.
Setting the Frequency Selection Range for Operation in VFO Mode
VFO MODE Function
Sets the frequency tuning range while operating in VFO mode.
1 Rotate the DIAL, then touch [21 VFO MODE].
2 Rotate the DIAL to select the desired tuning range.
ALL Tuning continues to the next band when reaching the end of a band.
BAND Tuning continues to the other end of the current band when reaching
the end of the band.
Remark The default setting: ALL
Notifying a Call From a Remote Station by Vibration
Rotate the DIAL to select [22 VIBRATOR] to set the vibrator which notifies you of a call
from a remote station.
For details, see “Notification of a Call from a Remote Station by Vibration” on page 113.
Swapping the Dial Knob Functions
1
Rotate the DIAL, then touch [23 DIAL KNOB CHANGE].
2 Press the [CHANGE] key.
The VOL and DIAL knob functions are swapped.
Remark The default setting: the upper knob is DIAL.
To Next Page
Loading...
