Yaesu FT2DR - AF-DUAL Receive Function (Receiving Signals on Other Frequency Channels While Listening to Broadcast Radio); Listening to a Radio Broadcast Using the AF-DUAL Receive Function

100
Convenient Functions
AF-DUAL Receive Function (Receiving Signals on Other
Frequency Channels While Listening to Broadcast Radio)
The AF-DUAL Receive Function allows reception of a radio broadcast during standby
reception of A-band or B-band frequency (or frequency registered to a memory
channel). When standby reception is active, no audio is heard on the standby frequency,
however if a voice signal is detected, the reception of the broadcast radio will be
paused, and the receiver frequency will be heard.
Dual Receive (
see page 96) is a similar function. When using the Dual Receive
function, every time the transceiver checks for a signal on the specified memory
channel during radio reception, the radio reception is interrupted (approximately every 5
seconds). When using the AF-DUAL Receive Function, the radio reception is interrupted
only when there is a calling signal from another transceiver.
Listening to a Radio Broadcast Using the AF-DUAL Receive
Function
1
Set the A-band or B-band frequency (or Memory Channel/Home Channel) for
standby receive during broadcast radio reception.
Tips • You can listen to the radio while scanning the standby receive signal frequencies.
• You can listen to the radio while monitoring the standby receive signal frequency in dual
receive mode.
2 Press the key to set the A-band to the
operating band.
3 Touch [F MW].
The function screen appears.
4 Touch [A.DUAL].
The AF-DUAL function is activated.