Yaesu FT2DR - Displaying Your Location in Digital Mode; Setting the Standby Beep; Adjusting the Microphone Sensitivity Microphone Gain

134
Customize Menu Settings for Individual Use (Set Mode)
Set Mode: TX/RX Menu Operations
Displaying Your Location in Digital Mode
Set whether or not to display your location in digital mode.
1 Touch [2 DIGITAL].
2 Touch [3 LOCATION SERVICE].
3 Rotate the DIAL to select the desired setting.
ON Displays your location.
OFF Does not display your location.
Remark The default setting: ON
For details on the function, refer to the GM Function Instruction Manual.
Setting the Standby Beep
Set whether or not to emit the standby beep sound when the remote station completes
transmission.
1 Touch [2 DIGITAL].
2 Touch [4 STANDBY BEEP].
3 Rotate the DIAL to select the desired setting.
ON Emits the standby beep sound.
OFF Does not emit the standby beep sound.
Remark The default setting: ON
Adjusting the Microphone Sensitivity Microphone Gain
You can adjust the input level of the built-in microphone or an optional external microphone.
1 Touch [3 AUDIO].
2 Touch [1 MIC GAIN].
3 Rotate the DIAL to select the desired microphone sensitivity level.
Select a microphone gain level from LEVEL 1 to LEVEL 9.
Remark The default setting: LEVEL 5
Tips
• Increasing the microphone gain excessively can distort the sound or pick up the surrounding noise,
impairing intelligibility.
• Be sure to check the microphone gain whenever the microphone is changed.