Yaesu FT2DR - Setting the DTMF Code; Calling Only a Specific Station (New Pager Function); Enabling No-Communication Squelch Function PR FREQUENCY Function; Adjusting the Squelch Level SQL LEVEL Function

139
Customize Menu Settings for Individual Use (Set Mode)
Set Mode: SIGNALING Menu Operations
Setting the DTMF Code
By selecting [5 DTMF SELECT], the maximum of 16 digit DTMF code can be registered
for a telephone number to make a call through the public telephone line from a phone
patch.
For details, see “Using the DTMF Function” on page 103.
Calling Only a Specific Station (New Pager Function)
When using transceivers with a group of friends, specifying individual personal codes
permits directing a call to a specific station by selecting [6 PAGER].
For details, see “Calling Only a Specific Station New Pager Function” on page 116.
Enabling No-communication Squelch Function PR FREQUENCY
Function
Set a no-communication squelch frequency in steps of 100 Hz within the range from 300
Hz to 3000 Hz.
1 Touch [7 PR FREQUENCY].
2 Rotate the DIAL to tune in to a no-communication squelch frequency.
Select a no-communication squelch frequency in steps of 100 Hz within the range
from 300 Hz to 3000 Hz.
Remark The default setting: 1600 Hz
Adjusting the Squelch Level SQL LEVEL Function
Set the squelch level to mute the raspy noise heard when there is no signal.
1 Touch [8 SQL LEVEL].
2 Rotate the DIAL to adjust the squelch level from LEVEL 0 to LEVEL 15.
Remark The default setting: LEVEL1