Yaesu FT2DR - Turning On;Off the Transceiver at the Specified Time Timer Function; Password Function

149
Customize Menu Settings for Individual Use (Set Mode)
Set Mode: CONFIG Menu Operations
Turning on/off the Transceiver at the Specified Time
Timer Function
You can turn the transceiver to on or off at the specified time. Before using this function,
adjust the clock referring to “Setting Clock Time” on page 43.
1 Rotate the DIAL, then touch [11 TIMER].
2 Rotate the DIAL to select the desired option.
POWER ON Turns on the transceiver at the specified time.
POWER OFF Turns off the transceiver at the specified time.
3 Press the key.
4 Rotate the DIAL to set the hour, then press the key.
5 Rotate the DIAL to set the minute, then press the key.
6 Touch [TIMER ON] or [TIMER OFF] to set the timer function to on or off.
Touch [TIMER OFF] to deactivate the timer function.
Remark The default setting: □ (TIMER OFF)
Password Function
You can enter a 4-digit password to prevent a third party from using your transceiver
without permission. Once a password is set, the transceiver cannot be used unless the
valid password is entered.
1 Rotate the DIAL, then touch [12 PASSWORD].
2 Rotate the DIAL to select [ON].
ON Set the password.
OFF Does not set the password.
Remark The default setting: OFF
3 Press the key.
4 Use the numeric keypad to input your desired 4 letters using 0 to 9, A to D, * or #.
5 Press the key.
The registered 4 letters appear.
Tips
• To deactivate the password function, select [OFF] in step 2, then press .
• When the on-timer function is activated, the password function is disabled.
y Inputting the Password to Use the Transceiver
1 Press for over one second.
The password input screen appears.
2 Use the numeric keypad to input the password.
Input the password you registered.