Yaesu FT2DR - Page 82

82
Scanning Function
Programmable Memory Channel Scan (PMS)
Tips
• When a skip memory channel (see page 77) is registered to [L] or [U], or when the lower/upper
limit frequency is not properly registered, program memory channel scanning does not function.
• Press and hold the
key for over one second to enter Set mode, then configure the following
operating preference settings.
[CONFIG] → [3 BEEP] → [EDGE]: Sets whether or not the beep sound is emitted when the
frequency band edge or memory channel 01 is reached during scanning.
[SCAN] → [2 SCAN LAMP]: Sets whether or not the LCD is illuminated when scanning stops.