Yamaha F50A - Page 225

62Y3A11
6-26
1
2
3
4
5
6
7
8
I
2. Install the needle bearing into the lower
case to the specified depth.
È
For USA and Canada
É
For worldwide
NOTE:
• Install the needle bearing with the manufac-
ture identification mark
b
facing upward.
• When using the driver rod, do not strike the
special tool in a manner that will force the
stopper
c
out of place.
3. Install the sleeve, original shim(s), and
bearing outer race.
CAUTION:
Add or remove shims, if necessary, when
replacing the pinion or lower case.
NOTE:
• Apply gear oil to the inside and outside of
the sleeve.
• Install the sleeve with the projection
f
fac-
ing forward.
Driver handle
3
: YB-06071
Drive shaft needle bearing remover and
installer
4
: YB-06063
Drive shaft needle bearing depth stop
5
:
YB-34474
Driver rod SL
6
: 90890-06602
Needle bearing attachment
7
:
90890-06614
Bearing depth plate
8
: 90890-06603
Depth
d
: 132.5–133.0 mm (5.22–5.24 in)
Depth
e
: 182.5–183.0 mm (7.19–7.21 in)
É
Drive shaft taper roller bearing cup installer
9
: YB-06110
Bearing outer race attachment
9
:
90890-06627
Driver handle
0
: YB-06071
Driver rod LS
0
: 90890-06606
Drive shaft and lower case (F50/F50A)