Yamaha F50A - Assembling the Power Trim and Tilt Motor; Installing the Power Trim and Tilt

62Y3A11
7-76
1
2
3
4
5
6
7
8
I
8. Check the bushing
1
for damage or
wear. Replace if necessary.
Assembling the power trim and tilt
motor
1. Install the oil seal
1
and the bushing
2
into the motor base
3
as shown.
2. Attach the circuit breaker
4
onto brush 1
5
together with the brush holder
6
and
connect the wire lead
7
.
3. Install the springs
8
into the motor base,
then the brush holder into the motor base
together with the brushes and circuit
breaker.
4. Install the armature
9
, O-ring
0
, and
yoke
A
.
Installing the power trim and tilt
1. Fully tilt the outboard up, and then sup-
port it with the tilt stop lever
1
.
WARNING
After tilting up the outboard, be sure to
support it with the tilt stop lever.
Otherwise, the outboard could suddenly
lower if the power trim and tilt unit should
lose fluid pressure.
Power trim and tilt motor