Yamaha F50A - Disassembling the Propeller Shaft Assembly; Checking the Propeller Shaft Housing

62Y3A11
6-54
1
2
3
4
5
6
7
8
I
NOTE:
Install the bearing separator
2
between the
reverse gear and thrust washer completely,
then the other special service tools.
2. Remove the ball bearing.
È
For USA and Canada
É
For worldwide
3. Remove the oil seals and needle bear-
ing.
Disassembling the propeller shaft
assembly
1. Remove the spring
1
, and then remove
the cross pin
2
, dog clutch
3
, slider and
shift plunger.
Checking the propeller shaft housing
1. Clean the propeller shaft housing using a
soft brush and cleaning solvent, and then
check it for cracks. Replace if necessary.
Slide hammer and adapters
7
: YB-06096
Stopper guide plate
8
: 90890-06501
Stopper guide stand
9
: 90890-06538
Bearing puller
0
: 90890-06535
Bearing puller claw 1
A
: 90890-06536
Bearing housing needle bearing remover
B
:
YB-06153
Needle bearing attachment
B
:
90890-06612
Driver handle
C
: YB-06071
Driver rod L3
C
: 90890-06652
Propeller shaft housing (T50/FT50B, FT50C)