Yamaha F50A - Removing the Clamp Brackets; Installing the Clamp Brackets

BRKT
Bracket unit
7-45
62Y3A11
Removing the clamp brackets
1. Remove the power trim and tilt or hydro
tilt. For removing procedures, see
“Removing the power trim and tilt/hydro
tilt” in this chapter.
2. Loosen the self-locking nuts
1
, and then
remove clamp brackets
2
and
3
.
3. Remove the trim sensor
4
.
Installing the clamp brackets
1. Install the trim sensor
1
onto the port
clamp brackets.
NOTE:
Adjust the trim sensor after installing the
power trim and tilt.
2. Assemble the clamp brackets and the
swivel bracket by installing the self-lock-
ing nuts
2
, then tightening them to the
specified torque.
3. Install the power trim and tilt or hydro tilt.
For installing procedures, see “Installing
the power trim and tilt” in this chapter.
Self-locking nut
2
:
23 N·m (2.3 kgf·m, 17 ft·lb)