Yamaha F50A - Disassembling the Tilt Cylinder; Disassembling the Trim Cylinder

BRKT
Bracket unit
7-63
62Y3A11
Disassembling the tilt cylinder
1. Hold the power trim and tilt
1
in a vise
using aluminum plates
a
on both sides.
2. Loosen the tilt cylinder end screw
2
, and
then remove it.
WARNING
Make sure that the ram is fully extended
before removing the end screw.
3. Drain the fluid.
Disassembling the trim cylinder
1. Hold the trim cylinder
1
in a vise using
aluminum plates
a
on both sides.
NOTE:
Place the trim cylinder in the vise horizon-
tally.
2. Loosen the trim cylinder end screw
2
,
and then remove it.
CAUTION:
Do not damage the check valve
b
when
loosening the end screw.
Trim and tilt cylinder wrench: YB-06175-2B
Cylinder-end screw wrench: 90890-06544
Trim and tilt cylinder wrench: YB-06175-2B
Cylinder-end screw wrench: 90890-06544