Yamaha F50A - Page 255

62Y3A11
6-56
1
2
3
4
5
6
7
8
I
È
For USA and Canada
É
For worldwide
NOTE:
• Install the needle bearing with the manufac-
ture identification mark
a
facing toward the
oil seal (propeller side).
• When using the driver rod, do not strike the
special tool in a manner that will force the
stopper
b
out of place.
2. Apply grease to the new oil seals, and
then install them into the propeller shaft
housing to the specified depth.
È
For USA and Canada
É
For worldwide
NOTE:
Install an oil seal halfway into the propeller
shaft housing, then the other oil seal.
3. Install the thrust washer
0
and ball bear-
ing
A
to the reverse gear
B
using a
press.
È
For USA and Canada
É
For worldwide
Driver handle
1
: YB-06071
Bearing housing needle bearing remover
2
:
YB-06153
Driver rod SS
3
: 90890-06604
Needle bearing attachment
4
:
90890-06612
Bearing depth plate
5
: 90890-06603
Depth
c
: 25.0–25.5 mm (0.98–1.00 in)
Bearing housing oil seal installer
6
:
YB-06269
Driver handle
7
: YB-06071
Ball bearing attachment
8
: 90890-06655
Driver rod LS
9
: 90890-06606
Depth
d
: 4.5–5.5 mm (0.18–0.22 in)
Propeller shaft housing (T50/FT50B, FT50C)