Chapter 3 Fuel Injection Equipment
_2_.
_G_o_ve_r_n_o_r
_____________________________
3,4]H3(B)(CJE
3.
Don't forget
to
mount the washers
to
both sides
of
the governor lever.
(8)
After you have mounted the O-ring, tape the governor
lever
in
the opposite direction, and mount
the
E-shaped
stop rings
on
!he grooves
at
both ends.
NOTE:
After mounting the governor lever assembly, make
sure the governor lever assembly moves smoothly.
3-12
(9)
Fit the stop lever return spring to the end
of
the gover-
nor lever shaft.
(10)
Hook the governor spring
on
the
control lever shaft and
tension lever hook with radio pliers.
(11)
Pull the governor link
as
far
as
possible towards the
governor case mounting surface, insert the governor
link pin in the fuel control rack pin hole and fit the
snap pin
on
it.
Printed in Japan
HINSHI-H8009
To Next Page
Loading...
