YASKAWA NX100 - Page 148

8.3 Alarm Message List
8-44
4130
NETWORK
APPLICATION
ERROR
6 An error occurred in the exclusive
process of the storage area control
table of the Ethernet function.
• Rotate the mode selector switch on the pro-
gramming pendant to release the mode set-
ting which has been set to "REMOTE", then
rotate the switch again to set back to
"REMOTE".
• If the error occurs again after releasing the
mode setting of the switch and setting back
to "REMOTE", turn the power OFF then
back ON.
If the error occurs again, contact your
Yaskawa representative.
7 Time-out occurred in the re-initial-
ization response receiving process
of the Ethernet function.
8 An error occurred in the re-initializa-
tion response receiving process of
the Ethernet function.
9 Receiving data size error occurred
in the re-initialization response
receiving process of the Ethernet
function.
30 An error occurred in the Web server
task mail receiving process of the
Ethernet function.
31 An error occurred in the FTP server
task mail receiving process of the
Ethernet function.
32 An error occurred in the FTP client
task mail receiving process of the
Ethernet function.
40 Illegal e-mail data were received in
the Web server task of the Ethernet
function.
41 Illegal e-mail data were received in
the FTP server task of the Ethernet
function.
42 Illegal e-mail data were received in
the FTP client task of the Ethernet
function.
50 An error occurred in the data size
written to PCI of the Ethernet funci-
ton.
51 An error occurred when the request
to write PCI data was received in
the Ethernet function.
52 The request of the undefined trans-
mission was received in the Ether-
net function.
53 An error occurred in the transmis-
sion request of the Ethernet func-
tion.
54 The transmission request without
data was received in the Ethernet
function.
55 The transmission request of illegal
data length was received in the
Ethernet function.
60 Illegal mail data ware received in
the DNS task of the Ethernet func-
tion.
61 Illegal mail data was transmitted in
the DNS task of the Ethernet func-
tion.
100 An error occurred in storing process
of memory which is used in the
Ethernet function.
Alarm Message List
Alarm
Number
Message
Sub
Code
Cause Remedy