YASKAWA NX100 - Page 182

8.3 Alarm Message List
8-78
4445
DATA PRESET
ERROR
Data error occurred at job prereading reinter-
pretation.
• Reset the alarm, reselect the job, and then
try again.
If the error occurs again, contact your
Yaskawa representative.
4 • An error occurred in prereading
operation process.
5 • A_BANK conversion has not been
completed.
255 • An exceptional error occurred in
job execution process.
4446
OVER VARI-
ABLE LIMIT
The variable value exceeded the limit.
Change the variable data type for storage or
correct the job, so that the variable value is
within the limit.
0 The variable value exceeded the
limit.
1 The value for the binary (0/1) data
type variable exceeded the limit.
2 The value for the signed 1-byte
data type variable is less than the
minimum value.
4 The value for the signed 2-byte
data type variable is less than the
minimum value.
6 The value for the signed 4-byte
data type variable is less than the
minimum value.
8 The value for the real-number 4-
byte data type variable is less than
the minimum value.
32770 The value for the signed 1-byte
data type variable exceeded the
maximum value.
32771 The value for the unsigned 1-byte
data type variable exceeded the
maximum value.
32772 The value for the signed 2-byte
data type variable exceeded the
maximum value.
32773 The value for the unsigned 2-byte
data type variable exceeded the
maximum value.
32774 The value for the signed 4-byte
data type variable exceeded the
maximum value.
32775 The value for the unsigned 4-byte
data type variable exceeded the
maximum value.
32776 The value for the real-number 4-
byte data type variable exceeded
the maximum value.
32780 The value for the label-name type
variable exceeded the maximum
value.
32781 The value for the job-name type
variable exceeded the maximum
value.
32782 The value for the character-string
type variable exceeded the maxi-
mum value.
Alarm Message List
Alarm
Number
Message
Sub
Code
Cause Remedy