94
ZIP2x2 User’s Manual
8.4.5.5 Call Disconnect
This parameter programs the phone’s behavior after the other party disconnects a call. You can
program the phone to remain silent or play a busy tone.
To configure the call disconnect behavior:
1. Select Menu | User Settings | Audio | Call disconnect. The display shows:
This example shows four rows, though in practice the display can show only three rows at
once.
2. Select an option using the Up and Down keys:
• Select busy tone to program the phone to play a busy tone after the other party
disconnects from a phone call.
• Select busy tone time to program the phone to play a busy tone for five seconds after the
other party disconnects from a phone call
• Select silent to program the phone to remain quiet after the other party disconnects from
a phone call.
3. Press the OK button to save your selection and return to the Audio menu.
8.4.5.6 Second Call Tone
This parameter specifies the call waiting tone that is played when you are talking on the phone
and the phone receives another call. To configure the second call tone:
1. Select Menu | User Settings | Audio | Second call. The display shows:
This example shows seven rows, though in practice the display can show only three rows at
once.
2. Select an option using the Up and Down keys. When you move to a different selection, the
phone plays the particular sound.
3. Press the OK button to save your selection. If you make a selection other than custom, the
phone changes ring tone and returns to the Audio display shown in section 8.4.5.
See section 8.4.5.10 on page 96 for information on selecting custom audio features.
Call disconnect
}busy tone
busy tone time
silent
Second call tone
}short high beep
long high beep
short low beep
long low beep
custom
silent
To Next Page
Loading...
