Configuration
LITECOM, Commissioning and maintenance instructions 17.0 | 04.2024 | en 117
Presence is detected by presence detectors. One or more sensors
can be selected as required. The sensor does not have to be
located in the effective range of the presence linking.
Select the type of presence linking (presence, absence,
presence/absence), as well as a run-on time and dead time. Also,
define whether presence linking is always enabled or depends on a
scene.
The action timeframe is a time in which the function is enabled.
· Timeframe 1 – 3: Define the action timeframe of the presence
linking using a maximum of three timeframes. A timeframe of
00:00–24:00 is stored as a default (presence linking always
enabled).
· On: Weekday when presence linking is active. More than one
weekday can be selected.
· Exceptions: Date group with entries on which presence linking
does not occur. More than one date group can be selected.
Note
Date groups must be defined in advance in the
Calendar app.
For more information see Section Calendar
Table 67: Functions of the "Presence linking" app
103
To Next Page
Loading...