Maintenance
LITECOM, Commissioning and maintenance instructions 17.0 | 04.2024 | en 168
11.6 Faults
The Faults app provides information on which field device faults are currently unresolved in your LITECOM system
at any given time.
Path: App overview > Faults
The following information is displayed for each fault:
· Date and time: information on when the fault occurred.
· Path: information on where the fault occurred. The path consists of the room\group\device name, e.g. Room
1\Group 1\LIGHTS - 6400000100
· Type: Type of device assigned during addressing, e.g. Standard, Direct, Warm-white. This information is
required above all for special luminaires, in order to determine the light source of the special luminaire for which
the fault has occurred. The individual light sources for a special luminaire are summarised when special
luminaires are created. As soon as the special luminaire has been created, only the special luminaire is
displayed in the system image; the light sources no longer appear individually.
· Message: information about the fault
As soon as a fault has been corrected the corresponding entry disappears from the list.
Note
Messages about the occurrence and correction of faults can still be seen in the log.
For more information see Section Log
You can also save a list of the current faults as a CSV file. The save location depends on the browser settings.
Note
This function is not supported by display devices with iOS operating systems.
167
To Next Page
Loading...