Configuration
LITECOM, Commissioning and maintenance instructions 17.0 | 04.2024 | en 54
10.1.1 Date, time and time zone
The date and time are used as the basis for all time linking (e.g. conditional scene recall at a specific time) and for
timestamps for test book and log entries.
Path: App overview > Basic settings > Date and time
Note
The date and time are automatically changed depending on the time zone. For this reason, we
recommend proceeding as follows to set the date, time and time zone:
1. Open the Date and time app.
2. Set the time zone.
3. Tap the tick mark.
ÜThe changes are saved.
ÜThe LITECOM CCD is restarted. This process may take several minutes. Then start page is
then displayed.
4. Open the Date and time app again.
5. Set the date.
6. Set the time.
7. Tap the tick mark.
ÜThe changes are saved.
ÜThe Basic settings view is displayed.
To Next Page
Loading...