Zumtobel LITECOM - Network Settings

Configuration
LITECOM, Commissioning and maintenance instructions 17.0 | 04.2024 | en 59
10.1.3 Network settings
You can define whether the LITECOM CCD control device uses a static IP address or automatically obtains the IP
address. A static IP address is assigned by default.
i
Note
The following default settings are stored in the LITECOM CCD:
· Default IP address of the LITECOM CCD: 10.10.40.254
· Default subnet mask: 255.255.0.0
Changing the device name and device designation
You can change the device name of the LITECOM CCD. The device name is LITECOM CCD by default. The
LITECOM-Touchpanel TCI and LITECOM Mobile App use this device name to establish a connection to the
LITECOM CCD. For easier assignment, we recommend giving the LITECOM CCD installed in your LITECOM
system a unique name (e.g. LITECOM CCD ground floor). You can also change the device designation of the
LITECOM CCD. The device designation is an abbreviation of the device name used in an Infinity system to
uniquely assign the RGA address of a device (e.g. luminaire) to a control device.
i
Note
The maximum length of the device designation is four characters, such as
o LC01 as an abbreviation for LITECOM CCD 01.
o 0001 as an abbreviation for the first LITECOM CCD in general.
o GF01 as an abbreviation for the first LITECOM CCD on the ground floor.