Maintenance
LITECOM, Commissioning and maintenance instructions 17.0 | 04.2024 | en 169
11.7 Data backup
It is possible to back up your LITECOM system data. In the event of the loss of any data, this can be used to
restore your LITECOM system data.
Note
This function is not supported by display devices with iOS operating systems.
Path: App overview > Data backup
There are two ways to back up your LITECOM system data: by creating a complete data backup or partial data
backup.
On the computer or mobile device; save
location depends on the browser settings.
Locally on the LITECOM CCD control device
The LITECOM CCD control device and
computer or mobile device must be
connected via an Ethernet cable or wireless
access point.
LCP file (software version 1.3 and higher)
Note
In software version 1.2 and lower,
the data was saved in an LKP file.
The data from LKP files can also
be restored in LITECOM systems
with software version 1.3 and
higher. Device-specific settings for
field devices are not included in
these data backups, however.
· Manual: six manual data backups can be
saved. As soon as the seventh data backup
is created, the oldest manual data backup
is overwritten.
· Automatic: the data is automatically backed
up every night. Three automatic data
backups can be saved. As soon as the
fourth data backup is created, the oldest
automatic data backup is overwritten.
To Next Page
Loading...