Commissioning
LITECOM, Commissioning and maintenance instructions 17.0 | 04.2024 | en 47
9.5 System image
The system image is a list-like representation of the LITECOM system in the web application. It contains rooms,
groups and the devices installed in the system. In addition – if available – zones and the addressed control
equipment therein are also displayed.
The following contains an overview of the functions in the System image app.
Path: App overview > System image
Figure 10: “System image” app view
The app overview can be accessed via this button.
As soon as you tap the button, the RGA address is displayed instead
of the device name (e.g. 2-1-2). This is an address used in
LUXMATE systems for communication purposes. It is based on the
following address scheme: room address/group address/individual
address.
This function is mainly used when the LITECOM system has been
addressed via the IB-Tool, for example. In this case RGA addresses
are assigned. Meaningful names are then assigned in the LITECOM
web application to indicate real conditions (e.g. Shop window left).
Note
If the device displayed is a sensor conforming to DALI-2,
the RGA address is displayed on one side instead of the
device name and additionally, all instances are listed
below with their own RGA address.
Locate luminaires, motors and sensors visually
Luminaires, motors and sensors can be located visually to determine
where they are situated in the field.
· A visually located luminaire responds by switching to the maximum
level.
· A visually located set of blinds responds by moving to the lower
end position.
· A visually located sensor flashes (red, for example).
There are three levels of location:
· an individual device (luminaire, motor or sensor)
· all luminaires, motors and sensors in a group
· all luminaires, motors and sensors in a room
To Next Page
Loading...