Zumtobel LITECOM - Page 49

Commissioning
LITECOM, Commissioning and maintenance instructions 17.0 | 04.2024 | en 48
Function
Brief description
(4)
View the values from the sky scanner
This button can be used to view the current values from the sky
scanner. If the sky scanner is added to the system via a link, the IP
address of the linked LITECOM CCD control device is also
displayed.
For more information see Section Control device linking
Delete or remove the sky scanner
The Delete button can be used to delete the sky scanner.
i
Note
· If the sky scanner is a linked device, the Remove
button is displayed instead of the Delete button.
· If the linked sky scanner is deleted on the original
LITECOM CCD control device, it is also deleted on
the linked LITECOM CCD control device.
For more information see Section Deleting or removing
linked devices
(5)
View the values from the weather station
This button can be used to view the current values from the weather
station. If the weather station is added to the system via a link, the IP
address of the linked LITECOM CCD control device is also
displayed.
For more information see Section Control device linking
Delete or remove the weather station
The Delete button can be used to delete the weather station.
i
Note
· If the weather station is a linked device, the Remove
button is displayed instead of the Delete button.
· If the linked weather station is deleted on the original
LITECOM CCD control device, it is also deleted on
the linked LITECOM CCD control device.
For more information see Section Deleting or removing
linked devices
Enable/disable sensors
The weather station can provide information on wind speed, wind
direction, outdoor temperature and rain depending on the sensors
used. Individual sensors can be disabled with the button on the right
side.
(6)
Assign device
With the button Assign you can change the device type and move a
device (room and group).
When the device is moved, the following rules apply:
· If the device is automated before being moved (e.g. daylight
linking, blind control, shows), the scene settings are reset to the
default values.
· If a fixed control value is assigned to the device before being
moved, this control value remains unchanged.
· If the device is assigned to a group which is part of a show, the
device adopts the settings defined for this show.
(7)
Configure device
The button Configure can be used to configure addressed devices.
For more information see Section Configure devices
(8)
Create new room
Create a new room. Assign a meaningful name that refers to the real
room (e.g. stairwell).
(9)
Select room
Select the room so that the groups in this room are displayed in the
right-hand column.
Select zone
Select the zone so that the control equipment in this zone is
displayed in the right-hand column. Zones are also indicated by the
following icon in the interface:
143
149
143
149
72