Chapter 16 Port Authentication
GS3700/XGS3700 Series User’s Guide
194
* Use this row to make the setting the same for all ports. Use this row first and then make
adjustments on a port-by-port basis.
Note: Changes in this row are copied to all the ports as soon as you make them.
Active Select this check box to permit MAC authentication on this port. You must first allow MAC
authentication on the Switch before configuring it on each port.
Tr u st ed - VLAN
List (Standalone
mode)
Enter the ID number(s) of the trusted VLAN(s) (separated by a comma). If a client’s VLAN
ID is specified here, the client can access the port and the connected networks without
MAC authentication.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel
to save your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
Table 81 Advanced Application > Port Authentication > MAC Authentication (continued)
LABEL DESCRIPTION
To Next Page
Loading...
