Chapter 58 Configure Clone
GS3700/XGS3700 Series User’s Guide
506
Figure 384 Management > Configure Clone (Stacking)
The following table describes the labels in this screen.
Table 255 Management > Configure Clone
LABEL DESCRIPTION
Source/
Destination
Port / Slot
(Stacking)
In stacking mode, a port is defined by a slot ID representing the Switch in the stack and a
port number.
Select the source port and slot (in stacking mode) under the Source label. This port’s
attributes are copied.
Enter the destination port or ports under the Destination label. These are the ports which
are going to have the same attributes as the source port. You can enter individual ports
separated by a comma or a range of ports by using a hyphen. For example, 2, 4, 6 indicates
that ports 2, 4 and 6 are the destination ports. 2-6 indicates that ports 2 through 6 are the
destination ports.
In stacking mode, you can select multiple destination slots.
Basic Setting Select which port settings (configured in the Basic Setting menus) should be copied to the
destination port(s).
To Next Page
Loading...
