1-12
<Sysname> display port combo
Combo-group Active Inactive
1 GigabitEthernet1/0/25 GigabitEthernet1/0/27
2 GigabitEthernet1/0/26 GigabitEthernet1/0/28
Table 1-6 display port combo command output description
Field Description
Combo-group
Combo ports of the device, represented by Combo port number, which
is generated by the system.
Active Ports of the Combo ports that are active
Inactive Ports of the Combo ports that are inactive
As for the optical port and the electrical port of a Combo port, the one with the smaller port number is
active by default. You can determine whether a port is an optical port or an electrical port by checking
the “Media type is” field of the display interface command.
display unit
Syntax
display unit unit-id interface
View
Any view
Parameters
unit-id: Unit ID.
Description
Use the display unit command to display information about the ports on a specified unit.
Examples
# Display information about the ports on unit 1.
<Sysname> display unit 1 interface
Aux1/0/0
Description : Aux Interface
Ethernet1/0/1 current state : DOWN
IP Sending Frames' Format is PKTFMT_ETHNT_2, Hardware address is 000f-e290-2240
Media type is twisted pair, loopback not set
Port hardware type is 100_BASE_TX
100Mbps-speed mode, full-duplex mode
Link speed type is force link, link duplex type is force link
Flow-control is enabled
The Maximum Frame Length is 9216
Broadcast MAX-pps: 500
Unicast MAX-ratio: 100%
To Next Page
Loading...
