1-7
Description
Use the test-enable command to execute an remote-ping test.
Use the undo test-enable command to disable an remote-ping test.
After you execute the test-enable command, the system does not display the test result. You may view
the test result information by executing the display remote-ping command.
Related command: display remote-ping.
Example
# Execute the remote-ping test defined by the test group “administrator-icmp”.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] remote-ping administrator icmp
[Sysname-remote-ping-administrator-icmp] test-enable
test-type
Syntax
test-type type
View
remote-ping test group view
Parameter
type: Test type.
Description
Use the test-type command to configure the type of the test.
Currently the system only supports ICMP test.
Example
# Set the test type of the “administrator-icmp” test group to ICMP.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] remote-ping administrator icmp
[Sysname-remote-ping-administrator-icmp] test-type icmp
To Next Page
Loading...
