1-24
Description
Use the reset counters interface command to clear the statistics of the port, preparing for a new
statistics collection.
If you specify neither port type nor port number, the command clears statistics of all ports.
If specify only port type, the command clears statistics of all ports of this type.
If specify both port type and port number, the command clears statistics of the specified port.
Note that the statistics of the 802.1x-enabled ports cannot be cleared.
Examples
# Clear the statistics of Ethernet 1/0/1.
<Sysname> reset counters interface ethernet 1/0/1
shutdown
Syntax
shutdown
undo shutdown
View
Ethernet port view
Parameters
None
Description
Use the shutdown command to shut down an Ethernet port.
Use the undo shutdown command to bring up an Ethernet port.
By default, an Ethernet port is in up state.
Examples
# Shut down Ethernet 1/0/1 and then bring it up.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] interface ethernet 1/0/1
[Sysname-Ethernet1/0/1] shutdown
#Apr 13 23:13:53:600 2000 Sysname L2INF/2/PORT LINK STATUS CHANGE:- 1 -
Trap 1.3.6.1.6.3.1.1.5.3(linkDown): portIndex is 4227650, ifAdminStatus is 2, ifOperStatus
is 2
%Apr 13 23:13:53:807 2000 Sysname L2INF/5/PORT LINK STATUS CHANGE:- 1 -
Ethernet1/0/4 is DOWN
%Apr 13 23:13:53:927 2000 Sysname L2INF/5/VLANIF LINK STATUS CHANGE:- 1 -
Vlan-interface3 is DOWN
To Next Page
Loading...
