3-3
HABP counters :
Packets output: 0, Input: 0
ID error: 0, Type error: 0, Version error: 0
Sent failed: 0
Table 3-3 Description on the fields of the display habp traffic command
Field Description
Packets output Number of the HABP packets sent
Input Number of the HABP packets received
ID error Number of the HABP packets with ID errors
Type error Number of the HABP packets with type errors
Version error Number of the HABP packets with version errors
Sent failed
Number of the HABP packets that failed to be
sent
habp enable
Syntax
habp enable
undo habp enable
View
System view
Parameters
None
Description
Use the habp enable command to enable HABP for a switch.
Use the undo habp enable command to disable HABP for a switch.
By default, HABP is enabled on a switch.
If an 802.1x-enabled switch does not have HABP enabled, it cannot manage the switches attached to it.
So, you need to enable HABP on specific switches in a network with 802.1x enabled.
Examples
# Enable HABP.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] habp enable
To Next Page
Loading...
