1-1
1 IP Routing Table Commands
The term router in this chapter refers to a router in a generic sense or an Ethernet switch running a
routing protocol.
IP Routing Table Commands
display ip routing-table
Syntax
display ip routing-table [ | { begin | exclude | include } regular-expression ]
View
Any view
Parameters
regular-expression: Regular expression, a string of 1 to 256 case-sensitive characters used for
specifying routing entries.
|: Uses the regular expression to match the output routing information.
begin: Displays the routing information from the route entry containing the specified character string.
include: Displays all routing information containing the specified character string.
exclude: Displays all routing information without the specified character string.
For details about regular expressions, refer to Configuration File Management Operation of this
manual.
Description
Use the display ip routing-table command to display the routing table summary.
This command displays the summary of the routing table. Each line represents one route, containing
destination address/mask length, protocol, preference, cost, next hop, and output interface.
This command displays only the currently used routes, that is, the optimal routes.
To Next Page
Loading...
