3-5
View
Any view
Parameters
None
Description
Use the display rip routing command to display RIP routing information.
Examples
# Display the information of the RIP routing table.
<Sysname> display rip routing
RIP routing table: public net
A = Active I = Inactive G = Garbage collection
C = Change T = Trigger RIP
Destination/Mask Cost NextHop Age SourceGateway Att
192.168.110.0/24 1 31.31.31.8 7s 31.31.31.8 A
200.1.1.0/24 1 31.31.31.8 7s 31.31.31.8 A
130.1.0.0/16 1 31.31.31.8 7s 31.31.31.8 A
Table 3-3 Description on the fields of the display rip routing command
Field Description
Destination/Mask Destination address/Mask
Cost Cost
NextHop Net hop address
Age Time elapsed after the route is advertised
SourceGateway Gateway originating the route
Att
Attributes of a route:
z A: Active route
z I: Inactive route
z G: Working state of the garbage collection
timer
z C: Change state
z T: Triggered RIP
filter-policy export
Syntax
filter-policy { acl-number | ip-prefix ip-prefix-name } export [ protocol ]
undo filter-policy { acl-number | ip-prefix ip-prefix-name } export [ protocol ]
filter-policy route-policy route-policy-name export
undo filter-policy route-policy route-policy-name export
To Next Page
Loading...
