3Com Switch 4500 Family - Display Ntdp Single-Device Mac-Address

1-50
Examples
# Display the topology of the current cluster.
<aaa_0.Sysname> display cluster current-topology
--------------------------------------------------------------------
(PeerPort) ConnectFlag (NativePort) [SysName:DeviceMac]
--------------------------------------------------------------------
ConnectFlag:
<--> normal connect ---> odd connect **** in blacklist
???? lost device ++++ new device -┤├- STP discarding
--------------------------------------------------------------------
[aaa_0.3Com:000f-e202-2180]
|
├-(P_0/40)<-->(P_0/6)[Sysname:000f-e200-2200]
|
├-(P_0/28)<-->(P_3/0/1)[Sysname:000f-e200-1774]
|
├-(P_0/24)****(P_1/0/6)[clie:000f-e200-5502]
|
├-(P_0/22)<-->(P_1/0/2)[aaa_5.3Com:000f-e200-5111]
|
├-(P_0/18)<-->(P_3/0/2)[Sysname:000f-e218-d0d0]
|
├-(P_0/14)<-->(P_1/0/2)[Sysname:000f-e200-5601]
|
├-(P_0/10)<-->(P_1/0/1)[aaa_7.Switch5500-EI:0012-a990-2241]
|
├-(P_0/4)<-->(P_0/2)[Switch 4500:000f-e200-00cc]
|
└-(P_0/1)****(P_0/1)[Sysname:00e0-fd34-bc66]
display ntdp single-device mac-address
Syntax
display ntdp single-device mac-address mac-address
View
Any view
Parameters
mac-address: MAC address of the device whose detailed information is to be displayed.
Description
Use the display ntdp single-device mac-address command to display the detailed information, which
is collected through NTDP protocol packets, about a single device. The information displayed by the
command is similar to that displayed by the display cluster members command. However, if you want