1-2
View
remote-ping test group view
Parameter
ip-address: Destination IP address in a test.
Description
Use the destination-ip command to configure the destination IP address in the test. Use the undo
destination-ip command to remove the configured destination IP address.
By default, no destination IP address is configured for any test.
Example
# Set the destination IP address in the test of the “administrator-icmp” test group to 1.1.1.99.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] remote-ping administrator icmp
[Sysname-remote-ping-administrator-icmp] destination-ip 1.1.1.99
display remote-ping
Syntax
display remote-ping { results | history } [ administrator-name operation-tag ]
View
Any view
Parameter
results: Specifies to display the test results.
history: Specifies to display the test history.
administrator-name: Name of the administrator creating the test.
operation-tag: Test operation tag.
Description
Use the display remote-ping command to view test result(s).
If a test group is specified using the arguments of administrator-name and test-operation-tag, the
system displays only the test result of the group; if not, it displays the test results of all the test groups.
Related command: test-enable.
Example
# Use the display remote-ping results command to display the test result of the test group whose
administrator name is “administrator” and operation tag is “icmp”.
<Sysname> display remote-ping results administrator icmp
To Next Page
Loading...
