1-4
Description
Use the display poe interface power command to view the power information of a specific port of the
switch. If the interface-type interface-number argument is not specified, the command displays the
power information of all ports of the switch.
Examples
# Display the power information of Ethernet 1/0/10.
<Sysname> display poe interface power Ethernet1/0/10
Port power :12400 mW
# Display the power information of all ports.
<Sysname> display poe interface power
PORT INDEX POWER (mW) PORT INDEX POWER (mW)
Ethernet1/0/1 0 Ethernet1/0/2 0
Ethernet1/0/3 0 Ethernet1/0/4 0
Ethernet1/0/5 0 Ethernet1/0/6 0
Ethernet1/0/7 0 Ethernet1/0/8 0
Ethernet1/0/9 0 Ethernet1/0/10 12400
……
<Omitted>
display poe powersupply
Syntax
display poe powersupply
View
Any view
Parameters
None
Description
Use the display poe powersupply command to view the parameters of the power sourcing equipment
(PSE).
Examples
# Display the PSE parameters.
<Sysname> display poe powersupply
Unit 1
PSE ID :0
PSE Legacy Detection :disable
PSE Total Power Consumption :0 mW
PSE Available Power :300000 mW
PSE Peak Value :0 mW
PSE Average Value :0 mW
To Next Page
Loading...
