3-17
Use the undo rip version command to restore the default.
By default, the version of RIP running on an interface is RIP-1 and RIP-1 packets are sent in the
broadcast mode.
If RIP-2 runs on an interface, RIP packets are sent in the multicast mode by default, which reduces
resource consumption.
Table 3-4 Receive mode of RIP packets
RIP version
RIP-1 broadcast
packet
RIP-2 broadcast
packet
RIP-2 multicast
packet
RIP-1 √ √ —
RIP-2 broadcast mode √ √ —
RIP-2 multicast mode — — √
Table 3-5 Send mode of RIP packets
RIP version
RIP-1 broadcast
packet
RIP-2 broadcast
packet
RIP-2 multicast
packet
RIP-1 √ — —
RIP-2 broadcast mode — √ —
RIP-2 multicast mode — — √
Examples
# Run RIP-2 on the interface VLAN-interface 10 and send RIP packets in the broadcast mode.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] interface Vlan-interface 10
[Sysname-Vlan-interface10] rip version 2 broadcast
rip work
Syntax
rip work
undo rip work
View
Interface view
Parameters
None
Description
Use the rip work command to enable the interface to receive and send RIP packets.
To Next Page
Loading...
