1-9
Description
Use the peer-public-key end command to return from public key view to system view.
Related commands: rsa peer-public-key, public-key-code begin, public-key peer.
Examples
# Exit public key view.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] rsa peer-public-key Switch003
RSA public key view: return to System View with "peer-public-key end".
[Sysname-rsa-public-key] peer-public-key end
[Sysname]
protocol inbound
Syntax
protocol inbound { all | ssh }
View
VTY user interface view
Parameters
all: Supports both Telnet and SSH.
ssh: Supports only SSH.
Description
Use the protocol inbound command to configure specific user interface(s) to support specified
protocol(s). The configuration will take effect at next user login.
By default, both SSH and Telnet are supported.
As SSH clients access the SSH server through VTY user interfaces, you need configure the VTY user
interfaces of the SSH server to support remote SSH login.
To Next Page
Loading...
