1-3
mirroring-group
Syntax
mirroring-group group-id { local | remote-destination | remote-source }
undo mirroring-group { group-id | all | local | remote-destination | remote-source }
View
System view
Parameters
group-id: Number of a port mirroring group, in the range 1 to 20.
all: Specifies to remove all mirroring groups.
local: Specifies the mirroring group as a local port mirroring group.
remote-destination: Specifies the mirroring group as the destination mirroring group for
remote port mirroring.
remote-source: Specifies the mirroring group as the source mirroring group for remote
port mirroring.
Description
Use the mirroring-group command to create a port mirroring group.
Use the undo mirroring-group command to remove a port mirroring group.
The mirroring group you created can take effect only after you configure other parameters
for it.
Note that, a Switch 4500 supports configuring only one destination port in local port
mirroring or one reflector port in remote port mirroring. That is, on a Switch 4500, there can
be only one effective local mirroring group or one effective remote source mirroring group.
The two mirroring groups cannot coexist.
Related commands: display mirroring-group.
Examples
# Create a port mirroring group on the local switch.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] mirroring-group 1 local
mirroring-group mirroring-port
Syntax
mirroring-group group-id mirroring-port mirroring-port-list { both | inbound |
outbound }
undo mirroring-group group-id mirroring-port mirroring-port-list
To Next Page
Loading...
